The suppressor under test: gas blowback and repeatability of the zero

Deep dive6 min read§14.6VOL-14-A02

Of the five signatures one deserves a practical follow-up more than the others, because it concerns the shooter before the designer: the gas that blows back, which gets breathed. Beside it belongs a quantity that is not a signature at all, but without which the table of offsets in Chapter 29 is waste paper: the repeatability of the mount.

A cost of the suppressor that gets little discussion is the one you breathe. The shot releases gas and particles. From the thermochemical calculation for a double-base powder the most abundant gases are carbon monoxide, carbon dioxide, nitrogen and water vapor, with smaller quantities of hydrogen, ammonia, methane, hydrogen cyanide and hydrogen sulfide; the particles carry the metals of the cartridge: copper, zinc, lead, antimony, barium, tin. The test standard requires the measurement of three gases (carbon monoxide, ammonia, hydrogen cyanide) and of the metals, in a closed 1 m³ chamber in which the rifle fires 3–5 shots per measurement: a single shot already takes carbon monoxide past 300 ppm in that volume, and with several shots 1,000 ppm is exceeded. What matters to the shooter is the distinction between the emission at the muzzle and the gas blowing back out of the ejection port and the mechanism: the latter comes out close to the face, and its measurement is expressly prescribed for suppressors, because the suppressor holds pressure and sends part of the gas back through the rifle. Oil and solvent left on a hot rifle contribute to the vapors as well.

Victrix Academy

The preview ends here

The rest is reserved for Academy members: the full text, the figures and the tables. Joining takes two minutes. Reading time: 6 min read.

Sign up Log in