The zero and the climate: when it is the rifle that moves
The temperature sensitivity of powder (Chapter 7) is the best known explanation for a zero that changes with the season, but it is not the only one. A system zeroed in one climate and used in another, which is the normal condition for anyone who travels by air, can move its mean point of impact for reasons that lie in the rifle itself: the polymers and composites of the stock and the chassis that change dimensions and stiffness, the interface between scope and receiver that expands differently on its two sides, the barrel heated from one side only by the sun. Formal small-arms qualification testing has a protocol for exactly this, and its logic can be reproduced in miniature with an environmental chamber or, more modestly, with a whole season of recorded checks.
The formal protocol zeroes the complete systems (rifle, scope, reference ammunition) at 21 °C and then never adjusts them again. After 24 hours at −30 °C a ten-shot group is fired straight out of the environmental chamber at 100 meters from a machine rest, with the same point of aim, and its center and its D90 are measured, that is, the diameter that contains 90% of the shots (Chapter 33); without cleaning, the systems are held 24 hours at the next temperature and a new group is fired, going up 15 °C at a time to +60 °C and then back down by the same steps. The centers, plotted against temperature, show two things a shooter has to know about the system in hand: the slope, that is, how many tenths of a MIL for every 15 °C, and any hysteresis. A system that at +15 °C on the way up is not where it is at +15 °C on the way down has a component that does not come back. Two variants complete the picture. The first is humidity: groups before and after a long stay in a hot, humid environment (the protocol’s order of magnitude is a month at 40 °C and 95% relative humidity), with the practical caution that coming out of hot and humid into cool air fogs the scope; it pays then to wrap the rifle, not the scope, in a cloth and wait about an hour before firing. The second is sun from one side: the rifle is irradiated on one flank with a solar-spectrum source for 10 and then for 30 minutes, with a group immediately afterward and one after it cools. The laboratory version separates the culprits with an elegant method: a mirror at the muzzle sends a laser, placed at the center of a target at 25 meters, back onto a millimeter grid, while a camera behind the scope films the reticle. By the law of reflection the angle between incident and reflected ray is twice the deflection of the barrel, and comparing the barrel’s drift with the reticle’s says how much of the movement belongs to the rifle and how much to the scope mounting.